Common problems with LED light strips during maintenance:

1. Anti static: Due to the fact that LED is an electrostatic induction photosensitive resistor, if anti static measures are not taken properly when repairing LED light strips, it will burn out the LED and cause consumption. It should be noted that anti-static soldering iron must be used for electric soldering iron, and maintenance personnel should also take anti-static measures (such as wearing electrostatic induction rings and anti-static gloves).

2. High temperature weather: The two key components of LED light strips, LED and FPC, are all products that cannot be continuously heat-resistant. If FPC is exposed to high temperatures or exceeds its bearing temperature, it can cause bubbles in the covering film of FPC, immediately causing damage to the LED light strip. In addition, LEDs cannot continuously withstand heat, as their chips may be burned out by high temperatures over time. Therefore, when repairing LED light strips, the electric soldering iron that needs to be selected must be temperature controlled, and the temperature should be limited to a certain range. It is strictly prohibited to change or set it arbitrarily. In addition, even so, it is important to note that during maintenance, the soldering iron should not stay on the LED pins for more than 10 seconds. If this time is exceeded, it is likely to burn the LED chip.

3. Short circuit fault: Many LED light strips have poor performance due to a short circuit fault at the foot. It is important to investigate the cause before maintenance. Otherwise, after hastily replacing a defective LED, it will continue to cause the chip of the LED to be penetrated by short-circuit capacity when plugged in again.

Therefore, before replacing a new LED light strip, it is important to first identify the cause and receive targeted treatment in order to achieve twice the result with half the effort. More light strip styles to choose from, welcome to continue lighting strip manufacturer.